If this goes somewhere, and I can get my hands on one I can definitely look at it.
4 Likes
Moon were definitely talking about the same mold. The shape can be anything.
I think it would be cool to put a double layer battery in too.
1 Like
Ok.
I have a particular style that I like but this is for everyone. Have you got any shapes in mind
I am going to design some hypothetical shapes right now on youtube. https://www.youtube.com/watch?v=C4qX7FJj6KE
There is some time available today to cut out this board. Does anyone know what size battery enclosure I need to be cutting for? Maybe I’ll wait. Let’s finalize this board.
1 Like
Hey I was watching that Livestream it was late at night and wasn’t paying much attention to it.
But when I was talking about shapes I was still talking about have a kicktail deck…and the shape I had in mind was something like this
2 Likes
yes in deed. I wanted to let people know we can build each board with a different shape. That is very quick and painless to program and set up for. The battery enclosure is what we haven’t set in stone yet.
1 Like
Anything like this possible
There are more questions I asked above, about the enclosure… Should we drill holes somewhere, should we make battery wire cuts somewhere? What else can we do to make an awesome deck?
I think leave the holes for the enclosure since it could be a pain in the ass for the builder
And can u add wire channels like the raptor? Of you can do it, if you can’t don’t worry
2 Likes
Ok, so If I cut a pocket out in the board out at 50x534x12.4mm you’re down to see it happen? Should I do a relief section out around the perimeter of the rectangle?
2 Likes
Relief section will be good and yes that size will be fine to see what we can do with it
1 Like
So basically right now we’re setting in stone the requirements for the battery enclosure. I would like someone who makes enclosures to chime in.
Should that be 150mm wide?
1 Like
haha yes, not 50
1 Like
That’s a good size. The milled out recess around that isn’t imperative but could add an extra level of finesse if the thickness of enclosure and seal is right. It could though add another level of complication at this stage, and in the interest of testing a concept and showing something tangible simple may be better.
3 Likes
@bigben makes some mighty fine enclosures
Did you decide on a final shape for the first few?
Loved what moon suggested https://www.electric-skateboard.builders/t/discussing-esk8-deck-doobie-39-deck-with-kicktail-milled-out-area-for-electronics/77848/62?u=skunk
1 Like
Shapes can be anything for everyone really. The shape I chose for myself is this one. I need that kick. Here is what that battery enclosure size looks like with this shape and overall config, 26" WB, ect.
3 Likes
I’m really into it.
I admittedly like slightly sharper corners but I really like the shape of the deck overall.
I’d definitely like to add it to my project list.
Didn’t think i would be happy i didn’t order that moonshine sidekick last week.
This will be way better, especially with a @bigben enclosure potentially. 
1 Like