Metr Pro - Next Gen Bluetooth Module

PixelatedPolyeurthan · June 25, 2019, 5:31pm

I am sorry if this is a stupid question but does this work if you pull out the UART connection out of my Evolve Carbon GT. Does the GT need the UART plugged in to work? Any way around this if not?

Thanks a million

rpasichnyk · June 25, 2019, 6:47pm

@Darkie02 @DAddYE go to Metr Settings and

enable Use location (it may have been disabled)
disable Prefer GPS

also make sure Metr has location services on Always in iOS Preferences

DAddYE · June 25, 2019, 8:20pm

After updating to iOS 13 I’m unable to test it (I think I might just need to give BT permission to metr)

xsynatic · June 26, 2019, 12:10am

How would i use the metro pro and the flipsky vx1 remote which also connects via the uart port?

ZachTetra · June 26, 2019, 1:33am

Someone has a splitter they’re working on

bsancken · June 26, 2019, 2:31am

xsynatic · June 26, 2019, 6:19am

Oh yes! Thanks for that. I hope the product is finished soon

Darkie02 · June 26, 2019, 6:56am

Prefer GPRS was on all the other things were ok didn’t need changing. Will give it a test later.

bevilacqua · June 26, 2019, 8:19am

@StefanMe is also using IOS 13, does your Metr App work Stefan?

PixelatedPolyeurthan · June 26, 2019, 12:30pm

Sorry but is my question above really that bad for no one to answer it

rpasichnyk · June 26, 2019, 12:50pm

You must have VESC®-based ESC. If you have another controller, the app will not work for you. For example Boosted, Evolve, Meepo, WowGo, Backfire have another type of controller and are not compatible

PixelatedPolyeurthan · June 26, 2019, 4:31pm

@rpasichnyk thanks. Sorry again

ZachTetra · June 26, 2019, 4:37pm

Has anyone tried a METR Pro with the FSESC dual 6.6 plus yet?

McErono · June 26, 2019, 7:48pm

@rpasichnyk auto record does still work here and just updated to 4.8

rpasichnyk · June 27, 2019, 5:32am

Should work fine with FSESC dual 6.6

UART https://flipsky.net/collections/electronic-products/products/dual-fsesc6-6-plus-based-on-vesc6?ref=mdmzmvq-huw4

VESC6 https://metr.at/setup

keithcys · July 1, 2019, 10:03am

Sorry I’m new with vesc here. Does it only works in certain fw? I currently running Dual FSESC6.6 with fw3.57

Ricco · July 2, 2019, 5:08pm

Where can I find the source code for the Metr Pro Firmware v4.8?

McErono · July 2, 2019, 5:29pm

Metr isn’t open source…

Ricco · July 2, 2019, 5:34pm

The Metr Pro Firmware v4.8 is Firmware for VESC based ESCs right?

McErono · July 2, 2019, 5:35pm

4.8 is the firmware of the BT module not the ESC