Apple Watch Support would be sick! Just short look on my wrist to Check battery AWESOME.
Is there any chance to sort the “modes”?
Apple Watch Support would be sick! Just short look on my wrist to Check battery AWESOME.
Is there any chance to sort the “modes”?
Just started shutting myself cuz the beta ran out and I didn’t know what was up. Once I found the link to the App Store I never bought an app so quick in my life.
I guess you were installing it again for some reason? As long as you have it as an app already it can’t expire no?
I was using the one from Beta Flight, said that the beta ran out so I downloaded the actual app from the app store
I purchased your app. But it stopped working, didn’t make any changes to the board .
Using ack 3.102
Is this App still on the App Store ? I can’t find it
Yes, It is called Xmatic
Just connected HM-10 module to VESC. Bought app, checked connections with multimeter, everything’s ok. RX/TX crossed, even I tried to connect them straight to corresponding pins. Baud rate 9600 bps App config: PPM + UART I checked it, wrote app config few times to be sure.
And nothing, ble blinks red led, my iPhone 6 @ iOS 12 doesn’t seem to see anything. What am I doing wrong?
Board fw 338 hw 410
Seems like people are having problems with the app working? Was it working before I pushed the update for NRF module? I will take a look later today, I didnt change anything except allow the NRF to be detected, thats very strange.
double data doesnt require a can bus, that is only for changing configurations. I might add a quadruple… option.
@Risewithin i will have that soon just been busy.
@StefanMe Maybe :]
@craigthemachine did it only stop working after switching from beta -> app store version?
@anymorez did you check if you selected the bluetooth device in settings and it lists your device as default device?
Perhaps iOS 12 related?
I had a couple apps and services fall over and die.
Been working great on iOS 12 (even betas) for me.
Can anyone confirm having this app work with a Metr module? I’m not having any luck.
I can confirm. It works.
Assuming this is your firmware ?
This is stock FW3.40
I’ll update the firmware when I get home and try it again.
iPhone X fully updated. Focbox x 2 canbus
Ok, changed UART in the VESC settings to 9600 baud and now it works with both apps.
Nice to have so much data.
Alright I will have an FAQ page in the app in the next update haha!