You are welcome. Anyhow the upgrade that the app shows the last ride even when the board is not connect works as long you don’t close completely the app. Then us not possible anymore. Just ti let you know.
I also think I understand why when I set the lower speed and watt it really slow down but doesn’t respect the limit. I made a video and basically the left motor spins faster (master VESC with uart module attached) than the slave. This thing doesn’t happen to me when I ride in the let’s say full power mode. Here the video, I couldn’t go full throttle without weight because the motors start rattling, probably because they try to overpass the watt limit.
Hope it helps
Edit: Is the master connected motor that spins slower, which make sense because it is the one that send the signal to the slave. So is the slave that spins faster in the movie. Sorry for the misunderstanding.
As I said with full power mode I do not have it. I just wanted to let you know in case you see something more. To me was not a coincident that the slave Vesc is the one that can not keep the limits in this case. Nevermind, It does slow down the board for people that wanna try it, so fine for me
Thx
Released a new version (1.76) of the app. Refactored a lot of the code in the background. So please report if you have new issues and write which version of the firmware you use.
The Dark theme was not shown correct in videos. So please give it another try now. I think it looks great now.
It can take a couple of hours before the new version is available at Google Play.
So your clone version works with oreo? do you happen to know which clone version you have?
“… While trying to mimic the original HM-10 by “Jinan Huamao technology Co” they differ by firmware, breakout board and daughter board. When ordering online it is very difficult to know which exact combination you will get…”
and where you got it from? If yours works, I could just order that one instead of waiting for the arduino and flashing the new software.
I would love to get Ackamiacs app working again!!
I haven’t checked on my main phone. I’ve been having to use a different phone to use this app. Thinking I’m just going to buy some new modules as updating them seems to be more of a hassle.
Just a little test while I had a minute. I really wish I knew how to edit!!! I strapped an old phone to my helmet this time to see how it worked. Not bad.
@SeanHacker off topic, seeing that you are using a GT2B, can you turn off your board and remote, then turn on JUST your board and see if goes full throttle after 30 or so seconds? Mine and @danielz is having that issue
Thx
