Please keep us in the loop for use in a 12s configuration 
Edit: do you have any other specs/information that would highlight some of the aspects of this motor?
Wait I thought that the whole point of moving away from 50 mm was that it was sub-par for esk8t, why are we going back?
just ordered two of these but my card got declined twice and on the third try it went throught please let me know if i got charged 3 times
They also have great heat transfer into the motor mount, would be nice to develop a water-cooled motor mount to utilize this.
@Michaelinvegas Thank you! The factory specs are a bit higher than what I have listed. Me specs are based on actual usage and motor temps on a single drive.
@delta_19 These are great little motors and they work really well so they definitely disprove that 50mm is inadequate. They are actually on the verge of being too powerful for the current drive systems.
@ecuadorche Sorry about that, our credit card proccesor will do that sometimes. You were only charged once 
Thank you for your order!
so standard 10" calibers are out for dual rear unless you have extended axels and a couple of spacers, which could limit your choices of mounts. What mounts are you recommending and on what trucks? I like the idea of a wider wheelbase, so i want to try it out.
1 Like
Think the list needs to be updated 
also looking at it the mounting holes are really close to the edge, did you manage to get 63mm mounting holes? or is that just a trick of the camera?
This is very similar to Evolve GT motor, very nice!
These look exactly like what is on the new evolve, and that thing is rocketing up grassy hills with pneumatics.
I also like the fact that the can is almost completely sealed from debris.
1 Like
What size bullet connectors are on the motor? its not listed on the shop page.
The motors come with 4mm bullet connectors. Thanks for catching that!
@cmatson @laurnts A motor designed to survive the asphalt environment is bound to be popular!
@delta_19 They are set at 30mm. They fit well on @torqueboards mounts.
1 Like
even the V4 with only 63mm mounting holes?
No, they only work on v3 mounts.
well that sucks i think all mounts but the v4 are getting discontinued.
No worries, we will have something available soon.
4 Likes
Dimentions 50 x70mm,… is 70mm with shaft length included ?
This is the same motor as EVOLVE so now 31% gradient with dual motors is possible 
3 Likes
Those are some sexy motors, would definitely consider them if was building a new board today.
Are these made by Maytech? I wonder if Evolve gets them from the same place.
So you will have a mount available?