The JET SPUD 29" is back again! 😜

What was the cost of shipping to EU ? Last time I was sending a deck the cheapest I had was with USPS but the cos of shipping was almost the same as as the cost of the deck :slight_smile:

It’s about $46 give or take…

1 Like

How large of a riser would it need to use those SuperFly with no wheel bite?

I use 1/2in risers on mine with 97mm flywheels, never any bite, could prolly go smaller.

4 Likes

sweet that’s probably what i’ll do on mine

Just ordered one of the last ones. This thing looks amazing!

No risers needed. Lol. Unless you have big feet and like deep carving.

2 Likes

What trucks are those? I’ve planned the evole supercarve trucks for my build with the 306mm axle, how long are those axles?

I think you had it right the first time.

LoL that was no accident, it was intentional.

There’s a company called evole that also makes super carve?

What kind of trucks mmaner?

They label their batteries that way

1 Like

That’s actually hilarious.

Those are actually MBS ATS 10mm skate trucks off an Atom 95 mountain board. I’ll have to measure the width when I get home later, but I think they’re around 15" axle to axle. They’re almost comically too wide, but I like to experiment. Plan is to grind some flat spots on the hanger so a 2 piece caliber clamp/mount will fit. Worked once for me, should work again.

caliber II 10/50’s

That’s what some folks are looking for, LoL. No kick pushing that deck lest you get wheel bite … on your FOOT

1 Like

I have a set of those too…and the 7in knobbys. Is the truck geometry not an issue for you?

lol of course you do

2 Likes

Another off to France! :fr:

3 Likes