I just got the sensorless 168kvs from HK.
As far as i know on a 20mm pulley, with thick chunky mounts it could do with a couple of mm, its short just under 4mm from being flush but its not critical as the pulley rim is one mm and the belt sits one mm in-ish from that.
ps my motors are jus test fitted with two screws at this time… dont panic
Ordering a box load of ready to go sensor kits might be an idea… they would sell quite nicely and be cheaper to ship worldwide and shizzle.
Ide be in for a couple.
Yeah there are two grub screws that hold it in place. They dig into the truck really well when torque down.
Just shipping the sensor is one idea however it doesn’t solve the phase wires or the shaft.
This is my current Sk3 with TB mount, the 3-4mm overhang isnt a massive deal but I just don’t like it.
The keyway is a bonus too.
@walleywalker , what camera is it? An video that shows quality? https://www.electric-skateboard.builders/t/no-words-just-pictures-delete-words-use-pm/2992/7143?u=mishrasubhransu
Mobius Actioncam. It’s setup for 1080p @30fps with a 135 degree fisheye lens (eBay sourced) right now. The housings are custom and 3D printed and there’s about 15" of extension wire to the camera module from the PCB. Video is great in regular light but gets a little funny when it’s dark. I’ll see if I can load up a ride video in a bit.
You are aren’t you? There can be only one. You get that off the ground then enertion will hate you and take back the title. lol
And this after I have just cut a disgusting great hole in a work of art.
I’d be happy to share the STL and parts list, but I’m 95% sure the setup will only work on the particular Bern helmet I have unless otherwise modified.
Here’s the video quality from the helmet cam.
“ LOCTITE 638 is designed for the bonding of cylindrical fitting parts, particularly where bond gaps can approach 0.25 mm. The product cures when confined in the absence of air between close-fitting metal surfaces and prevents loosening and leakage due to shock and vibration.”
Video quality is pretty for. I would be able to to the CAD stuff. So there Mobius action camera has an in-built camera, do they have a setup with external camera? Do you have a pic of the setup before mounting everything in the helmet?
My suggestion get fur for your microphone to hide those wind noises 
It does come with an internal camera module, but it’s very easily removable and extendable. I own the wide angle version “B” lens. There are both 8" and 2" - 26pin extension cables available for purchase the original Mobius Actioncam, though Mobius doesn’t recommend more than 8" of extension as the signal can suffer. I also purchased the bigger 820mah battery for the setup, and re-positioned the battery above the PCB housing on the back of the helmet to keep it low-profile. I unfortunately didn’t take any pre-build photos. Someone made a pretty good SW replica of the camera assembly which I utilized and modified for my 3D printed housings.
Edit, the wide angle lens I had to take measurements and rebuild from scratch.
Burn or cheap one ply TP?
Ha! I actually wish it were poo
Maybe willpark16 died and is haunting all of us
Did you ever get that refund?
What happened?
