Didn’t know Brent did skydiving
yes, board pop out to the road.
Middle aged men should not be falling off at +40k’s Mine was a full acceleration cut out. Felt like full brakes while leaning fully forward. Now a bit scared of the beast untill I make sure it wasn’t a brake issue. Hope you’re ok Karl.
i fall all the time… im just that clumsy.
Can I request for an iron sight or a red dot holosight? need extra precision on my firefly.
https://www.electric-skateboard.builders/t/no-words-just-pictures-delete-words-use-pm/2992/8833?u=riako Hoooooo my … lord of esk8 !!! FKN Gorgeous work !
Falling, and being 13, is not anywhere close to the same as the same fall, except while being 40-something. It’s like ten times worse. The only good news is you’ve had longer to practice not falling in the first place.
As soon as I plugged the antispark in there was a large spark and I quickly tried to remove the plug but it would not move the plug instanty got hot enough to melt the solder so I broke the connection by pulling the wire off the plug.
What did I do wrong should I have put the antispark on the negative cable?
Could it have been a defective plug? I’m kind of worried if anything else got damaged.
The inrush current was way too high. It must have been something over 70A I believe. It had to be at least so high that the connector or the plasic weldeld together Where you using cheap xt90 connector’s? Otherwise, I got no explanation
Could have sworn i read a post that someone thought they got fake xt90 Connectors.
Well it is a 12s8p. I’m going to have to test my next loop key first on one if my smaller batteries not inside if the board.
Where did you get the xt90 connector?
The antispark one or the regular connector. The antispark I had laying around I think I originally got them on Amazon but the others in the batch have worked.
The antispark is an xt60 or xt90?
I have some cheap regular tx90 connectors mixed with good ones I may have used those if it makes a difference.
Xt90 connector.
Put this on the wrong thread. I see the green “L” but perhaps its not really a XT90s. there’s loads of fake ones out that don’t actually work
In my opinion, the only possibility is that somehow the current got way too high and melted the plastic or welded the connector together.