With standard 265mm belts that the mounts are normally sold with on 15t motor pulley
1 Like
Alright, I’ll get to work on it tomorrow when I have time. I have the same mount and belt size so it should be easy
1 Like
Oh wait, what’s the diameter of that motor pulley? Need to make sure there’s enough clearance with the draft angle
1 Like
25mm diameter
1 Like
How do you manage to make these stay? I cannot get my mounts to stay tight it seems, no matter how much torque applied.
First key is use a socket. Not an Allen ot twist handle
I push the mount flush against the truck in this direction to give no room to move as it’s already as far back as it can go if I run into something
I tighten it into place. Then back one out at a time and apply loctite and torque it to final position.
They won’t move if you use a socket. Handled hex drives, Allen’s, and screw drivers with hex inserts just won’t give enough leverage to create the torque for the set screw teeth to bite.
2 Likes
lol ur right xD I have a whole TB setup for dual drive and F*** alen keys haha, they wont fit… and i am also running the 100mm MBS wheels so i am curious to see where this goes
@ShutterShock I drilled a very shallow little hole just a hair under the diameter of the insert screw. When I torque the screw in, it’ll drive it’s chamfered end into the drilled hole and that shit will never move. Of course, loctite 243
1 Like
I did that the first few times… Until I figured out a socket is good enough
1 Like
I like this way because If for any reason I need to remove the mount, I can put it right back exactly where it was
1 Like
Huh awesome I will have to try that. Time to get a 4mm hex socket lol
Hey therr. Lol did you ever get a chance to work on this? 
If not just tell me to buzz off.
lmao sorry my bad, had it on hold for a while and forgot about it. I actually almost finished it a few weeks ago but I just never got a chance to finish it up and export it. Here ya go: https://drive.google.com/file/d/1qxxIaL4OOtAJLD6FlrMiwyoIBOfkMby8/view?usp=sharing
Not 100% sure if it’s gonna clear the belts though. Needs some further testing. Lmk if you need me to print it for you (it’s not free bruh).
2 Likes
@Deckoz There’s also some on Thingiverse - https://www.thingiverse.com/search?q=torqueboards&sa=&dwh=115ac997c327fea
Hey thanks man. I should be good on the printing! I’ll let you know how it goes!
Thanks man but. With 20mm metroboard pulleys…and 107s most of those aren’t compatible.
1 Like
Lol impossible I know I can’t be the only one with TB mounts on TB 218s with TB 6374 and 107s… I just may be the few with metroboard pulleys… 
2 Likes
Does this work for reverse mounts as well?
Can’t think of a reason why it wouldn’t 