Space Cell 3 with enclosure by Enertion

ESK8 Electronics
1

Hello guys I just recieved my space cell 3 with enclosure by Enertion and I was curious if anyone has installed this before and if so can you post pictures? Trying to figure out the best way to put the screws included. Thanks!

2

Drill 1/4" holes in your board and hammer in the rivets with a rubber mallet. You can see my pics here

http://www.electric-skateboard.builders/t/honey-driver-honey-velocity-v3-deck-caliber-iis-80mm-kegels-83mm-abecs-dual-om5065-200kv-space-cell-pro4-diy-pulleys-enertion-pulley-neal-bearings-enertion-mounts-benchwheel-winning-remote-chaka-vescs-build-complete/5760/41

3

Thanks! Doing my buils up tonight! Will post pics when completed!

4

Any idea what thread size the screw that come with are?

5

I’m not sure but I think they’re the same size as truck screws.