You donāt have to update it all the time like you would a computer. It is fine if you run it with the firmware that is on it now.
4 Likes
Carbon Fiber can also interrupt your signal to your controller as well if it is between the receiver and the controller
has the remote/receiver such a weak signal?
Nope as far as I know itās the farrady cage effect 
1 Like
Yep; doesnāt matter how strong the signal is. (within reasonā¦ at some point the heat from the eddy currents induced in the faraday cage will vaporize the cage itselfā¦ but youād need about 15 orders of magnitude of power to reach those levels)
1 Like
Yepā¦ but not using an RC Receiverā¦ 
1 Like
Make sure to use distilled water so thereās no leftover minerals or anything when you let it dry. (If you go the soap and water method)
3 Likes
also carbon fibre is conductive , so make sure any edges are coverd or your batteries will short etc
Whatās the water for man
Cleaning PCBās if they get excessively grimey.
Aw thanks man , at first , I was thinking that that whould counter react the Faraday effect , my mind was like how ???
If you didnāt know, you can follow the reply chain by clicking the little back arrow on my comment on the right corner 
Yea man , IM not that much of the noob
1 Like
Where could I find the bearing spacers for 12mm ? Iām using matrix trucks(old version) & trying to have a spacer in between my bearings. I tried looking for it but I donāt think Iām writing the correct way to look for it. Iām writing 10mm x 10mm x 12mm & what Iām looking for is not coming up
I wouldnāt worry too much. Those little lipos puff pretty easily.
1 Like
Every single time I go to aluminum spacers .com I end up leaving again because they have a hot steamy love affair with Freedom Units and they seem to not be getting help for their addiction.
One good place to find spacers is the bearings themselves ā the inner raceway is the perfect size, only question is it the correct width?
Thatās a good thought 
hmmm
Have too think about this one
Using the MBS rockstar hubs