Need connector for my Bestech BMS

Send me your address i have set just pay me the shipping

2 Likes

I think the seller should have them in a bag that comes in the with the bms if u have no luck let me know

Contact the person you bought it from first. He should have included the connectors

1 Like

Those look like “JST-XH” connectors

The 8-pin version is sometimes referred to as “7S”. 2-pin might be called “1S”

I thought the same, that these were JST-XH, the same as used on lipo batteries. But its not.... they dont fit.

Oh, my BMS from another vendor is different. Then in that case it is probably JST-PH

What’s the pitch between pins?

2.5mm JST-XH 2mm JST-PH (most likely this one) 1.5mm JST-ZH 1mm JST-SH

1 Like

2.5mm same as JST-XH But the plastic connector does not have the same form facter like my regular jst-xh connectors on my lipo batteries

So, here is what I would do.

Basically, pull the plastic off the pins and connect JST-XH.

Or, alternatively:

tear the plastic until JST-XH fits :slight_smile:

1 Like

You mean hack it chop it bend it till they fit

Should have asked u to sell this one

Why bend it if the pitch is the same.

1 Like

Just get the right block that fits i have them

Looked it up, in that case they should be:

2.5mm JST-EH

Not really common. But something you can search for.

1 Like

Received the missing wires from @hornet90 Thank you very much. Love this forum …

1 Like

Anyone have a spare 8 position JST-EH? They seem to be out of stock everywhere, and amazon/ebay prices are absurd.

Just solder the wires directly on

@hornet90 does anyone have an extra pair of these for the same bms

I dont but if i was stuck i would cut plastic cover off and solder the wires on