Mountain Board Machined Parts/ Designs

How much for the AT truck and motor mounts? I have AT12 trucks but I am pretty sure they’ll fit.

Its $98.00 clamps, mounts and hardware plus shipping

1 Like

Interested in a set for dual motor for MBS Matrix 1. PM sent

can you Shipping too Germany i m interested for 2x

3d printed wheel gears are on evolve website for 29.00 if that’s what your calling a flywheel

@rithblu Do you make mounts for this truck? It looks like the older Matrix pro MBS trucks, which I’m looking for

witch trucks are you referring to? Matrix 1st gen are ATS.

i thought the ATS where the non-spring trucks? I have the older matrix pros; theres a feature for a handbrake to attach to the newer matrixs don’t have.

Post 154 looks like the mounts I need; it has the profile for the handbrake. The ATS trucks looks like this: (no springs)

image

This one? Matrix 1 20180212_173430 IMG_4541

1 Like

yes! 10 char

Cool ! I can have a set ready to ship tomorrow morning.

I didn’t see these on your website. How much for a pair of mounts and crossbars? Do you sell pulleys/belts as well?

No pulley/belts at this time .

The clamps for the mounts and cross bar I have to custom make, the cross bar is a little tricky because I don’t know how long to make it to your pacific setup. I would recommend that you get the mounts, pulley, belt first installed get everything where it need to be and aligned , so you can get better measurement for the cross bar.

Mounts for Dual Motor is $107.00 + shipping Cross Bar is 47.00 + shipping

I have 4 pairs ready to ship.

MATRIX II PRO Motor Mounts Clamps 20180727_193010 20180727_193022 20180727_193106 20180727_193656

9 Likes

Very nice. Any chance that you could add an idler on your mounts?

I was thinking something like this using the existing hole, but if you have something in mind. 20180730_112124

3 Likes

That might be too high. I think it should be around this area 20180730_120550

2 Likes

They do need to be closer to the pinion gear if your using that small of idler gear. If your going to use the existing hole I would recommend a 30mm idler pulley along with a 435-440mm belt for dual idlerz15330562620391675074055

7 Likes

I think 440mm belts are going to be ones needed so I done have to remove idler gears to remove the front two motor bolts. It’s a little tight with 435mm and I still have a little room to the rear for the motor