Life goes on and on and on
4 Likes
How did you balance your wheels? Mine wobble quite a bit (because of the valve?)
I haven’t yet but was thinking of using beads
ooops this is very poor editing
3 Likes
IMO its not save to use the Truckextension with the wide Fivestar Hubs on Matrix2 Trucks. I told @Riako last year about and i still think the same!
3 Likes
arrggh my posts are eating themselves
9 Likes
I’m going to miss that terrible vinyl table cloth
2 Likes
That looks pretty solid with the double bolts on each side of the binding. Are those inserts in the correct position to double as the mounts for the regular bindings when you want to switch? I like the idea of being able to switch bindings in the same holes. And make sure you don’t short yourself on stance width. I have those freeboard bindings on a drop through deck and they are pushed out as far as possible, but still feel like my stance is too narrow.
Also, are you gonna be doing rail slides on your enclosure? 
1 Like
We use M3 Self tapping but if you are going to use a lot of pull out force (for the bindings) I’d recommend using M4 and higher.
2 Likes
I’m melting!
5 Likes
I like cake
2 Likes
What top speed will you have if it’s 1:6.25?
this is nuts
1 Like
Awesome !!! 
haha
did it get the nut at the end ? Or we just have to insert a screw at the end ?!
1 Like
What’s this for?
crackle snap
1 Like
Excatly ! 
well find sir !!
And, yes, megastar 9" fit the kit with some shim/washer with the Trampa Direct Drive Hub Adapters But I prefer your solution, cheaper, like that I could keep my lighter 5*!
extender for e-toxx MBS matrix kit @moon
1 Like
I also love skateboards, don’t you?
1 Like
hey where da posts at?
3 Likes
Love this build!
What’s the rear truck printed button mount you got there?
1 Like