Can you please take a look at my diagram and to see if I got it right? Thank you.
2a charge is fine.
Your diagram needs more detail concerning the balance wires. Namely, you need to show the numbers of the bms balance socket and 3s batteries will have 4 balance wires. Bottom line. Your main connections look good but I can’t tell anything about the balance wires and if you get those wrong, you’ll fry the bms
1 Like
That is not correct
Thank you very much for taking the time and drawing the diagram! I thought their BMS supports 6s~10s no?
They sell bms’s for all voltages but you have to order one for the specific voltage your running.
here is a link for the same bms but for 9s battery.
http://bestechpower.com/333v9spcmbmspcbforli-ionli-polymerbatterypack/PCM-D223V1.html
And your gonna need a 37.8v charger
1 Like
Thank you. Just to be clear, I cannot use a charger that has a higher charging current than my nominal current which is 37.8 Volts?
You can not use a charger with higher voltage than the voltage of a 9s Lipo pack at full charge. Lipo cells at full charge will be 4.2v 4.2 x 9 = 37.8
Just search eBay for " 37.8v charger" I ran the search and found at least three 37.8v 2a chargers
Nominal voltage is 3.7v per cell or 33.3v for 9s
You want the charger to match your battery’s voltage at full charge or else it will not fully charge the battery.
2 Likes
Gotcha. 
Does anyone have a extra bms
What size?
For those Lipo 10s
I have one I have just taken out if a new build. I’m going a different direction and more than likely will not need it.
I also have 10 2s 5ah 30c hardcase lipo packs for sale. They have been made into two 10s lipo packs. They can be used as two separate 10s packs or wired in parallel for a 10s2p 10Ah pack. This is how I used them and they have been used for 3 charge cycles.
I have a new 37.8v charger in the UK that I’m never going to use if you were EU way.
Holy shit @Namasaki since the last time I visited this thread in January you’ve really had your work cut out for you answering questions! Thanks so much for your insightful contribution! I’ve recently ordered some of my parts now that I’ve gotten around to some extra cash.
Anyhow, I’m running a single 6375 R-Spec on 10s 8000mah and it works great. This new battery setup will be used with the R-Spec but will be switched to the new Carvon v4s as soon as I receive it! My question to you is: would it be better to go with the 12s over this 10s with the Carvon v4’s or is that overkill? Any pros or cons you can kindly point out? Thanks again brotha! I owe you a beer
I think the Carvons will do just fine with 10s. I would start with that anyway.
1 Like
Thanks for the quick reply. I do feel like 10S (with Lipos) is very safe. What’s questionable is the 12s with Lipos. I found my motor got pretty hot with a 12s after going up hills. Thanks for the update sir!