The spacers are pretty easy - use speed rings if you want, or you can cut some 13-15mm spacers.
Easily fits 97mm wheels, dual 6374’s and 15mm belts.
Or you can get the 107mm Abec 11 Electric Flywheels w/ 12mm belts. Just swap longer bolts and gtg!
The spacers are pretty easy - use speed rings if you want, or you can cut some 13-15mm spacers.
Easily fits 97mm wheels, dual 6374’s and 15mm belts.
Or you can get the 107mm Abec 11 Electric Flywheels w/ 12mm belts. Just swap longer bolts and gtg!
Yes. I flipped all of mine and no logo on the backside.
How wide are these compared to the Evolve GT double kingpin trucks?
Mockup of my setup. The extra long axels mean I can run a pulley with a bearing in it which also pushes the motors out a bit aaand there is still a spacer on the end of the axel. Fronts have spacer wheel spacer nut. I needed to file of the square corners off to make room for my pulleys.
can someone please post a picture of these mounted on an actual board - I remember just one by torqueboards himself. And maybe tell something about how they feel when riding?
Got just the rear on, temporary while I get dual drive built
For comparison front trucks are Psychotiller rkp trucks
I think the request was mounted to a board.
But yea I’m headed towards this exact same setup powered by a 12s4p, can’t wait.
Installed 1/2 in risers and the std bite…the 218s dont…
I’d agree, but it may have to do with softer brushings.
Can’t say definitively until both front and rears are on.
Hi,
is this (or something similar) possible to buy anywhere in Europe? I am building my first board and I would really like to have possibility for future upgrade regarding motors and belts.
Thanks in advance
Hey @thisguyhere, do you think dual 3674 SK3s would fit? Seems they are a bit longer than the torque boards ones. Thanks!
It would be super tight. If it worked youd have to have the motor pulley super close to the motor since the mounts will have to be taken to the very edge of the hangar. I think there would be fitment headaches but maybe possible. I’ll try eyeballing with my one sk3 later today.
Ahh damn, thanks for the heads up, appreciate it.
Caliber 50 are 10" = 220mm, is that not enough for dual 6374?
Nope, not with any combo I’ve tried.
10" is from the end of one axle to the other end, not the hanger width.
Hanger is 7.26" or 184.5mm.