Ahhh ok well that’s fine. Thanks for letting me know.
Are you sure you set the FOCBOX where the stuttering motor is attached to sensored. Make sure you detected the hall sensors and applied them.
Would not troubleshoot bench test cogging, focus on under load issues if any. Just IMO
1 Like
At full throttle one vesc randomly shuts down mid acceleration. Sometimes both of them shut down. They usually become responsive again 2 or 3 seconds later. It makes acceleration scary because I don’t want fall forward. I have tried 97mm abecs and 90mm abecs, it happens with both. I am 146 pounds, running a 12s4p lg hg2 battery pack, and two original vescs (not the x or focbox). How would I check for fault codes as I’m riding?
The fault codes will be stored until you power off the vescs, so just check them after a ride without turning off the board.
1 Like
Also https://www.electric-skateboard.builders/t/vesc-monitor-android-app/20888
But it might take a while to get the BTLE module and wiring
1 Like
I just finished adjusting settings. Turns out I was an idiot and forgot to measure and apply the Hall Sensor values, thus the noise in the previous video. I also deleted my last BLDC screenshot due to that error.
With CarvOn’s recommendation, I changed the motor max to 80. I just shot this short test video out at the office parking lot. It’s so quiet!
No helmet so I went slow.
3 Likes
Hello I have a problem, after the many delays Carvon finally sent me the motors. On 1rst of deptember yet any information has been updated to the tracking number. It only says pre shippment label created. I just wanna get my motors and Carvon is completely unresponsive and is not giving up any good support
Message them via Instagram or email CarvonSkates@gmail They might be swapping out the base plates at the moment. You might notice, mine is raw instead of black. That’s temporary due to stock. Its worth the wait ( easy for me to say, I know)
Slightly off topic, anyone remember the Carvon v3-4 truck angle? Assume they are the liquid precision CNC, but those come in 20-50 degree base plates as well as other baseplate options.
Need a little help. I’m experience cogging when I push the throttle too hard off the line. Easing into it seems fine. What do I need to do here?
10s3p, dual FocBoxes with split ppm.
Try lowering your batt max to 30A
Also why are all your erpm limits set at 0? (Foc doesnt care, just curious)
Thanks. I’ll try 30…Do you know the reasoning behind the cogging?
ERPM are 0 because that was not a actual screenshot of my settings, I just typed it in from my paper (I cross out and write in my changes on a print out for record keeping ) Too lazy drag in my board from the car =)
Could be saturating the motor, some times less is more. Also don’t think your batteries can handle 120A of batt current.
@Blasto Ben was talking about implementing some code or adding some manual adjustments to help deal with Saturation on his forum a while back. Do you know if that was ever done?
1 Like
Does this count as an EVO4? Hahaha, gonna go test the top speed on this board before I swap the V3’s on.
12 Likes
I think it’s time to change this thread title to the “V3 is here”
2 Likes
Thanks, super helpful!
Awesome, want to hear about torque drive performance as well as 4WD…and how you compare it to your speed drive experience!
1 Like